Stiga Park 4WD Série Manuel D'utilisation page 60

EN
Problem
6. Uneven cut.
7. Abnormal vibrations during
use.
8. With the engine running, the
machine does not move when
the drive pedal is pressed.
If one of the problems listed below occurs, replace the pertinent fuse.
9. The engine does not start or
stops immediately after start-
ing. The battery is charged.
10. Electrical cutting height
adjustment does not work
11. No electric function works.
The battery is charged.
If problems persist after having performed the above operations, contact your dealer.
Warning! Do not take on complicated repair work without the necessary equipment and
technical knowledge. The guarantee is automatically revoked and the manufacturer de-
clines all responsibility for any poorly effected repairs.
26
ENGLISH
Probable cause
The cutting device is dull.
Forward speed too high com-
pared to height of grass.
Cutting device assembly is full
of grass.
- The cutting devices are unbal-
anced.
- The cutting devices are loose.
- Loose parts.
- potential damages.
"Gear disengagement" lever in
disengaged position.
10A fuse faulty.
20A fuse faulty.
30A fuse faulty.
(Translation of the original instructions)
Solution
Check tyre pressure.
Contact an authorised service
centre.
Reduce the forward speed and/
or raise the cutting height.
- Wait for the grass to dry.
- Clean the cutting device
assembly
Contact an authorised service
centre for checks, replacements
or repairs.
Put into gear.
Replace the 10A fuse.
Replace the 20A fuse.
Replace the 30A fuse.