Getting To Know The Machine - Stiga Park 4WD Série Manuel D'utilisation

EN
1 INTRODUCTION
Read the instruction manual carefully
before starting the engine.
1.1 STRUCTURE OF THE MANUAL
The manual consists of the cover, an index, a
section including all the illustrations, the explan-
atory text.
The content is divided into chapters, paragraphs
and sub-paragraphs.
This manual contains some tables relating to the
various engines (if any).
To facilitate reading, highlight the data that refer
to the relevant machine or engine.
Figures
The figures in these instructions for use are
numbered 1, 2, 3, etc.
The components indicated in the figures are
identified with letters A, B, C, and so on.
A referent to the illustration is indicated with the
wording (2).
A reference to component A in figure 2 is indicat-
ed with the wording (2:A).
Headings
The headings in these instructions for use are
numbered as indicated in the following example:
2.3 INTENDED USE" is a subtitle of "GETTING
TO KNOW THE MACHINE" and is included
under this heading.
When referring to headings, usually only relative
numbers are specified, for example "See 2.3.1".
1.2 SYMBOLS
WARNING symbol. Failure to follow the
instructions provided may result in se-
rious injury to persons and/or damage
to property.
OBLIGATION symbol. Indicates an ob-
ligatory action to be performed.
PROHIBITION symbol. Indicates a pro-
hibited operation.
NOTE symbol. Indicates information or
in-depth analysis of particular impor-
tance.
REFERRAL symbol. Indicates a refer-
ence to information, the note indicates
where the information is.
4
ENGLISH
(Translation of the original instructions)
1.3 MANUAL STORAGE
Keep the manual in good condition and legible,
in a place known and easily accessible to the
machine user.

2 GETTING TO KNOW THE MACHINE

This machine is a garden tool and precisely a
front cutting ride-on lawnmower with seated
operator.
The machine is equipped with an engine which
drives the cutting device assembly protected by a
casing, as well as a transmission unit that moves
the machine.
The machine is articulated. This means that the
chassis is divided into a front and a rear section
which can be steered in relation to each other.
Articulated steering allows the machine to turn
around trees and other obstacles with an ex-
tremely small turning radius.
The operator is able to operate the machine
and use the main controls, always seated in the
operator's position.
The safety devices installed on the machine
will disengage the engine and cutting device
assembly.
2.1 MODELS [2WD]
This machine is fitted with rear traction.
The rear axle is equipped with hydrostatic drive
with infinite forward and reverse gears.
The rear axle is also equipped with a differential
to facilitate steering.
Front mounted accessories are driven by drive
belts.
2.2 MODELS [4WD]
The machine has 4 wheel drive.
Power from the engine to the drive wheels is
transmitted hydraulically.
The engine drives an oil pump which drives the
rear and front axles (wheels) through a hydraulic
circuit.
The front and rear wheels rotate at the same
speed.
To facilitate steering, both axles are equipped
with differentials.
Front mounted accessories are driven by drive
belts.