Dirt Devil Power Maid Mode D'emploi page 21

3 Fitting on accessories
3.4 Attaching the jet nozzle
8
3.5 Attaching the plastic brush
9
10
Select the jet nozzle (Fig. 8) if the application
area is similar to the application area for the
pinpoint nozzle, but the steam jet should be
more concentrated. The jet nozzle can only be
fit onto the previously mounted pinpoint noz-
zle.
1. Fit the pinpoint nozzle as described,
ZChapter 3.3, "Attaching the pinpoint
nozzle".
2. Firmly push the jet nozzle onto the pin-
point nozzle.
NOTE:
If you want to release the jet nozzle again,
you must pull it off the pinpoint nozzle force-
fully.
Select either the round or the wide plastic
brush (Fig. 9) depending on the space condi-
tions. Both brushes are used to remove stub-
born dirt that cannot be dissolved by steam
power alone.
NOTE:
The jet nozzle can only be fit onto the previ-
ously mounted pinpoint nozzle.
1. Fit the pinpoint nozzle as described,
ZChapter 3.3, "Attaching the pinpoint
nozzle".
2. Firmly push the plastic brush onto the pin-
point nozzle (Fig. 9.
NOTE:
If you want to detach the plastic brush you
must pull it off the pinpoint nozzle forcefully.
21