Use - EUROM 33.394.7 Manual D'instructions

• Check to ensure that the device is hanging firmly.
• You are advised to ask an electrician to connect the device to the mains and
then operate via a switch. You could also connect an appropriate socket. Make
sure that the electrical cable never gets too hot!
Important! If secured to the wall, the heat can radiate straight out and also around
35° downwards and upwards. Upwards is pointless and is also strictly forbidden!
This could overheat or melt the ceiling, lead to burn marks or even cause a fire.
Water could also get into the device.

Use

Check before each use:
- whether the device is showing any signs of damage.
- whether the device is still secured properly. Wind or gravity could loosen the
attachments over time.
- whether any objects, canvases, parasols, etc. have come within the safe
distances.
- whether the socket you are using provides the correct voltage (220/240V-50Hz).
Using the Outdoor heat panel
If this has all been checked, you can insert the plug into the socket. The device
should now work. Once the device is connected, it will take around 15 minutes to
heat up to its usual working temperature. To stop the device, switch it off or take
the plug out of the socket. Always give the device time to cool down.
Using the Outdoor heat panel (2400) RC
Set the switch to position 0, i.e. off. When you've made all of the checks, you can
connect the device to the mains using the external switch (or insert the plug into
the socket). Use the switch to set the device to the appropriate setting:
I = manual controls
II = remote control
 Manual control
Set the switch to I: the control light will come on. The device should now work.
Once the device is connected, it will take around 15 minutes to heat up to its
usual working temperature.
To switch it off, set the switch on the device back to 0. Then cut the power
supply using the external switch or take the plug out of the socket.
 Remote control
Set the switch to II: the device is now in stand-by.
Put 2 small batteries into the remote control (AAA-1.5V). Point the remote
control at the device and push the ON button. The blue control light will come
on. The device should now work. Once the device is connected, it will take
around 15 minutes to heat up to its usual working temperature.
To switch the device off, point the remote control at the device and press the
OFF button. The device is now in stand-by.
47