Finishing; Birch Wood Log Placement (Blko36) - Napoleon Riverside Série Manuel D'installation Et D'opération

9.0 fi nishing
EN
9.1

birch wood log placement (BLKO36)

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
PHAZER™ logs and glowing embers, exclusive to Napoleon, provide a unique and realistic glowing effect that
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing ef-
fect. Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat-activated curing process. Blocked burner ports can cause an incorrect fl ame
pattern.
1. Place log #1 on the rear bracket, ensuring the
notch on the right side of the log fi ts around
the pilot shield. Do not cover any burner ports.
3. Place the hole in log #2 on the stud located on
the left side of the burner.
24
W415-2978 / A / 10.07.21
note:
Log numbers are located on the bottom or back of the logs.
2. Place the two holes in log #3 on the two studs
located in the center of the burner. Do not
cover any burner ports.
4. Place log #5 along the front right side of the
grate and then pull it forward, ensuring the log
notches align with the grate posts.
Continued on next page