Service And Maintenance - Antari FT-200 Fire Training Mode D'emploi

DMX Channel Function
Channel 1
Fog
Fluid

Service and Maintenance

Do not allow the machine to become contaminated.
․
Remove dust from air vents with air compressor, vacuum or a soft brush.
․
Only use a damp cloth to clean the casing.
․
Before storing,
․
pump or heater.
It is recommended to run the machine on a monthly basis in order to achieve best
․
performance and output condition.
Excessive dust, liquid and dirt built up will degrade performance and cause overheating.
․
Pin
1
2
3
4
5
DMX Value Range
Only use Antari FLP water-based liquid for the FT-200 Fire
Training Fog Machine. The machine is tested and calibrated
with this liquid to get the best output performance. Warranty will
be voided if any other type of liquid is used, improper use of
liquid may lead to machine failure or malfunction.
run distilled water through the system to help avoid condensing the
Function
Ground
Data-
Data+
N/A
N/A
0 – 4
5 – 255
9
Function
Fog Off
Output 1-100%