England's Stove Works 25-CAB80 Manuel D'installation page 47

Vacuum Switch
 Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down.
 Remove the back panel of the unit, using a 5/16" wrench.
 Locate the vacuum switch as shown in the diagram below (on the left wall of the unit).
 Disconnect the power leads and vacuum hose from the vacuum switch, taking note of
where connections were made.
 Remove the (2) screws which hold the
vacuum switch to the vacuum switch
bracket, using a Phillips screw driver.
 Installation is the reverse of removal; be
absolutely certain the wires and vacuum
hose are connected as they previously
were (and according to the wiring diagram
in this manual).
 Visit youtube.com/heatredefined for
detailed service 'how to' videos.
Vacuum
Switch
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING COMPONENTS
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
47