England's Stove Works 25-CAB80 Manuel D'installation page 31

CONTROL BOARD SETTINGS – SIDE MOUNT CONTROL BOARD
The control board on this stove allows the user to adjust the heat output and convection blower speed, turn
the unit on and off, and test components for function (more on diagnostic mode later).
 The lower buttons on the control board (Low Fuel Feed, Low Burn Air, and Air on Temp) are not meant to
be adjusted during normal operation of the unit. These buttons are factory preset and should not be
adjusted by the user.
 To energize the unit and initiate a fire, press the "On" button. The LED above the button should turn green
and the control board should display "S U" shortly after pressing the button.
 To shut the unit down, press the "Off" button. The LED above the button should turn red and the board
should display "S d" shortly after pressing the button. This initiates the shut down sequence, and the
stove will remain in shut down mode until it has cooled down.
 To increase the heat output of the stove, press the "Up" heat range button. The number in the heat range
display window will increase, signifying that the control board is now adjusting the heat output to your
desired level. The blower speed will increase the same amount as the heat range, because the stove is
designed to operate with the blower speed greater than or equal to the heat range. Pressing the "Down"
arrow will decrease the heat range and blower speed.

To increase the blower speed without increasing the heat range, press the Blower Speed "Up" arrow until
the desired blower speed is shown in the display window. Pressing the "Down" arrow will decrease the
blower speed; however, the control board will not allow the blower speed to be set lower than the heat
range
.
This unit is meant to operate only with the main viewing door closed. Smoke spillage and an
inefficient, lazy burn will result from attempting to operate the stove with the door open.
In addition, using fuel other than wood pellets can create an unsafe situation and can also
generate excess carbon monoxide. Carbon monoxide is an odorless, colorless gas which can
The use of a carbon monoxide detector is strongly recommended.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
be deadly. Be sure to burn only wood pellets.
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Caution
31