England's Stove Works 25-CAB80 Manuel D'installation page 44

Auger Motors, Bearings & Shafts
 Before beginning any component replacement, be certain the unit is unplugged and thoroughly
cooled down. Also, make sure the hopper is empty before attempting to remove or replace the
top auger motor assembly.
 Remove the back panel of the
unit, using a
 Before loosening any auger
motor bolts, detach the power
leads from the auger motor.
 Locate the appropriate auger
motor assembly at the rear of
the stove, loosen the 5/16"
square head set bolt that is
positioned between the auger
motor and the auger block
bearing. This bolt tightens down
on the flat side of the gear shaft,
and locks the gear shaft and
auger shaft together.
 Once the bolt is loosened, the
assembly will slide from the
locking collar and auger shaft.
 To replace the top auger, all
pellet fuel must be removed
from the hopper as well as from the top auger assembly.
 Once this is done, the four ½" bolts that hold in the
bearing can be removed, and the complete auger
assembly may be removed from the stove.
 The auger bearings are a sealed unit and do not
require lubrication.
 Remove the ¾" shaft collar from the auger
shaft/bearing assembly.
 Loosen the two (2) 1/8" set screws on the end of the
auger bearing with a 1/8" Allen wrench, which will
disconnect the bearing from the shaft (the bearing
assembly and auger assembly can be replaced by
reversing this procedure; pull the bearing flush
against the ¾" collar before tightening the two 1/8"
set screws).
 Be sure to install a new auger bearing gasket when replacing an auger bearing.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
5
/ " wrench.
16
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Top Auger
5/16" Square Head Set Bolt tightens
on the FLAT side of gear shaft
44
Auger Bearing
Auger
Support Shelf
Bottom Auger