Burn Pot - England's Stove Works 25-CAB80 Manuel D'installation

 The stove and the flue system should be given a complete cleaning at the end of the heating season.
 Burn Pot: Remove the burn pot assembly, clean it thoroughly, and re‐install it (refer to Exploded Parts
Diagram in the rear of this manual and the Daily Maintenance section); this will require new gasket for
the burn pot. Be sure to tighten the set screws when you replace them, but do not over‐tighten.
 Combustion (Exhaust) Blower Cleaning: Although the combustion blower and blower housing were
designed to minimize ash build‐up, some fly‐ash will still accumulate there throughout the burning
season. The amount and type of ash will depend on the type of pellets and venting system, but
generally this accumulation will be mild. If, when cleaning the combustion blower, a large
accumulation of fly‐ash is found, cleaning the blower and housing should be performed monthly or
bimonthly to prevent this excess buildup.
Instructions
 Before beginning the combustion blower cleaning procedure, be certain the unit is unplugged and
thoroughly cooled down.
 Disconnect the venting system from the combustion blower just enough that you will be able to
remove the blower from the stove.
 Remove the left side access panel, using a 5/16" wrench.
 Remove the back panel of the unit, using a 5/16" wrench.
 Unplug the two power leads to the combustion blower, using the quick connect plugs.
 Loosen the five (5)
 Lift the combustion blower up and out of the stove. The gasket which seals the blower to the blower
tube is fragile, so take extra care when removing the blower. Even when being careful, though, it is
easy to tear this fragile gasket, and since an airtight seal is crucial here, you should replace this gasket
(Part # ‐ PU‐CBMG) every time the combustion blower is removed. Remove the gasket with a putty
knife, and install the new gasket by applying adhesive to the blower and installing the new gasket
(instructions and adhesive are provided with the gasket).
 With the combustion blower removed, use a utility vacuum to remove any ash accumulation in the
combustion blower tube on the stove.
 Using a soft paint brush, carefully remove any ash accumulation from the inside of the combustion
blower, and from the blower fan blade.
 Inspect the combustion blower motor for dust accumulation and carefully remove it, ensuring that all
air cooling holes into the motor are open and free of dust deposits.
 Install the blower in the reverse order as described above. Remember to check the condition of the
combustion blower gasket, and to reconnect the two wires which connect the blower to the stove's
control board.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
YEARLY MAINTENANCE
5
/ " self‐drilling screws which hold the combustion blower to the blower tube.
16
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
39