Simplicity Coronet Mode D'emploi page 16

Assembly
Check the Tires
Check the air pressure in the tires. Tires with too much
air pressure will cause the unit to ride rough. Also, the
wrong air pressure will keep the mower deck from
cutting level. The correct air pressure is: Front Tires
0,97 BAR (14 PSI), Rear Tires 0,69 BAR (10 PSI). The
tires were over inflated for shipment.
Check the Level of the Mower Deck
Make sure the level of cut is still correct. After you mow
a short distance, look at the area that was cut. If the
mower deck does not cut level, see an
authorized dealer.
Prepare the Engine
NOTE: The engine was shipped from the factory filled
with oil. Check the level of the oil. Add oil as needed.
See the engine manufacturer's instructions for the type
of fuel and oil to use. Before you use the unit, read the
information on safety, operation, maintenance,
and storage.
16
WARNING
Follow the engine manufacturer's instructions
for the type of fuel and oil to use. Always use a
safety fuel container. Do not smoke when
adding fuel to the engine. When inside an
enclosure, do not fill with fuel. Before you add
fuel, stop the engine. Let the engine cool for
several minutes.
Assemble the Fuel Cap
The fuel cap will be shipped in the Parts Bag and tape
will be placed over the fuel tank opening during
shipment. Before operation, remove tape from opening
on fuel tank and install fuel cap.
en