Instructions for use for the user
5.3. Heating up for the first time
CAUTION!
Smoke and odour formation when heating up for the first time
Work materials from the manufacturing process will be present on the
new heating elements. These evaporate when the sauna heater is heated
up for the first time. This produces smoke and an unpleasant odour.
Breathing in the fumes or smoke can be harmful to your health.
Perform the following steps when operating the sauna heater for the first time
and if the heating elements for the sauna heater have been changed. In this
way you will prevent damage to health due to the fumes and smoke produced
when heating up for the first time.
1. Heating the heating rods for the first time
a. Select the highest possible temperature on the sauna control unit.
b. Heat up the sauna heater for half an hour.
Do NOT stay in the sauna cabin during this period.
2. Heating the evaporator for the first time
a. Select a low temperature and high humidity on the sauna control unit.
b. Heat the evaporator WITHOUT water.
Do NOT stay in the sauna cabin during this period.
► After about 15 minutes, the excess temperature protection switches
off the evaporator.
c. Allow the evaporator to cool (for approx. half an hour).
d. Repeat step 2.b.
e. Allow the sauna cabin to ventilate thoroughly after heating up for
the first time.
f. If no smoke or odour is produced the next time the sauna heater is heated
up, you can start to use the sauna. If smoke or odour is produced again,
leave the sauna cabin immediately and repeat the initial heating up pro-
cess followed by ventilation.
WORLD OF WELLNESS
p. 17/26
EN