Operation; Commissioning; Temperature Settings; Time Settings - Sentiotec Onni Mini Manuel D'utilisateur

Instructions for installation and use

7. Operation

7.1. Commissioning

Connect all connectors according to the cir-
cuit diagram and then connect the control
unit (power unit) to the wall socket.
On/off lights up on the display.
Press On/off to switch the control unit on. The heating elements start to heat.
The cabin temperature and the operating time are displayed. The time is auto-
matically activated for 60 minutes or to the last selected time. If you press On/off
again, all functions (heating elements, light and music) are switched off.
Settings can be made for 10 seconds (flashing display), then it switches
to display mode.

7.2. Temperature settings

The desired temperature can be set with the Temperature +/- keys (30-70 °C).
When the temperature is reached, all heating elements are automatically
switched off. If the temperature drops 2 °C below the previously set tempera-
ture, the heating elements are automatically switched on again.
If the cabin temperature exceeds 80 °C, "HH" flashes in the display. All functions
are automatically switched off. Wait until the temperature drops below 70 °C,
and restart the cabin with ON/OFF.
The maximum temperature that can be reached in the cabin may be
lower than the desired temperature. This depends on the temperature
outside the cabin.

7.3. Time settings

The desired heating time from 5 to 60 min. can be set with the Time +/- button
(each press of the button = 1 minute). There is then a countdown of the minutes
and at "00" all functions are automatically switched off.
p. 9/10
EN