Servicing Victor; Cleaning The Turbine - Procopi Victor Manuel D'installation Et D'utilisation

Servicing VICTOR

Cleaning the turbine

1
2
3
4
towards the front of VICTOR. (N.B. :The back of
the vanes wear with usage. When reinserting a
vane into the hub, make certain that the worn side
of the vane is not inserted into the hub, otherwise
it may fall out.)
1. Place VICTOR on
a flat surface.
Remove the three
screws that secure
the top body cover
of the VICTOR
(photo 1).
2. Remove the top
body cover (photo 2) .
3.Remove the hose
cone assembly/ turbine
cover. (photo 3) .
Rock the assembly
back and forth to
loosen it for removal.
4. Remove the
turbine vanes by
sliding them out of
the hub (photo 4) .
When reinstalling
the turbine vanes,
make sure that the
vanes are inserted
in the hub so that
they fold forwards, or
31/56
5. Inspect the VICTOR's gears, drive shafts and
other internal components. Remove any visible
debris.
5
6
7
Check one last time that VICTOR's right-hand
wheel turns freely.
2008/05- Indice de révision : B - code : 0030010
6. Replace the hose
c o n e
assembly/turbine
cover, making sure
that it is pressed
firmly into place.
(photo 5) .
7. Rotate the right-
hand wheel
forwards to ensure
that the wheels,
turbine vanes and
gears turn freely
(photo 6) .
8. Replace
VICTOR's top body
cover (photo 7) and
replace the 3
screws.