Assembling The Hose; Connecting The Hose To Victor; Submerging Victor - Procopi Victor Manuel D'installation Et D'utilisation

STEP 2: ASSEMBLING THE HOSE
The first hose section is the section fitted with a white end-
piece and a float.
Connect the necessary number of hose sections to the
first or lead section. Finish with the green hose section
(stiffer).
Hose sections are easier to fit together when wet.
The fully assembled hose should be 2 sections longer
than the distance between the connection point (skimmer
or vacuum point) and the furthest point from it.Add or
remove sections to achieve the required length.
Connecting hose sections (wet)
STEP 3: CONNECTING THE HOSE TO VICTOR
a. Connect the white end of the lead
section to the hose cone on top of
VICTOR.
b. Connect the opposite end of the
hose to the bypass valve (available as
an option on two-wheel VICTOR).
c. Connect the bypass valve to the
hose cone.
On 2-wheel VICTOR the green hose
section will be connected directly to the
hose cone.
STEP 4: SUBMERGING VICTOR
a. Lower VICTOR and the hose into the water.
b. With the pump running, place the end of the hose away from VICTOR
end-piece
Hose
cone
against a pool return fitting until all air is purged from the hose and VICTOR.
Main hose
2 sections longer than the distance
between the connection point and the
Float
White
24/56
Float (pre-assembled)
Skimmer or vacuum point
point furthest from it
Bypass valve
Hose cone
White
end-piece