Trouble-Shooting - Procopi Victor Manuel D'installation Et D'utilisation

TROUBLE-SHOOTING

Problem: Victor is moving too slowly
Filter is clogged reducing flowrate
The pump strainer basket is clogged reducing flowrate
The hose is partially obstructed
VICTOR's suction port is partially clogged
Turbine vanes clogged/ jammed
Suction leak in plumbing
.
Insufficient flow and/ or suction pressure
Problem: Victor is stopped
The pump is not running
The pump is not primed
Clogging somewhere in the system
- Filter
- Pump strainer basket
- Tube and/or suction port
- Turbine vanes
The gears are not turning
The bypass valve is blocked in its open position
CAUSE
CAUSE
Stop the filtration pump before removing
debris from the cleaner or the hose
Clean the filter
Remove debris from the strainer basket
Remove the blockage
Remove the blockage
Remove debris from the turbine vanes (see "Servicing
VICTOR", page 13)
Inspect the hose for holes.
Inspect hose ends for proper connection. Replace hose
sections as necessary
Make sure that the bypass valve and hose cone are correctly
installed.
*Ensure that the other suction valves and nozzles are
correctly tightened
Adjust the 3-way valve to increase the amount of water sent
to VICTOR.
Turn the pump on
Prime the pump, check for suction leaks
- Clean the filter
- Remove debris from the pump strainer basket
- Remove debris from the hose and/or suction port.
- Remove debris from the vanes (see "Servicing the VICTOR
", page 31)
- Remove debris from the gears
- Remove debris from the turbine fins
(see "Servicing", page 30)
- Remove debris from the drive shafts, wheel gears and/ or
tracking cam
- After servicing, rotate the right front wheel "forward" to
ensure that all gears turn freely
(see the following table)
2008/05- Indice de révision : B - code : 0030010
27/56
!
CAUTION
SOLUTION
SOLUTION