Procopi Victor Manuel D'installation Et D'utilisation page 29

Problem: VICTOR falls over on its side
CAUSE
The float on the leader hose section is incorrectly
positioned
The hose is too short
Problem: Accumulation of leaves at the surface near the second skimmer
(if VICTOR is connected to the skimmer of a pool fitted with 2 skimmers)
CAUSE
The second skimmer is closed
Problem: VICTOR does not climb the walls
CAUSE
(see "VICTOR is moving too slowly, page 27)
Problem: Victor is climbing the wall too much
CAUSE
Tyre tread is worn
VICTOR is not turning often enough
The float should be 60 cm above the white tip of the
lead hose section
The hose should be 2 sections longer than the distance
between the connection point (vacuum point or
skimmer) and the point furthest from it. Add sections if
necessary.
.
SOLUTION
Adjust the opening of the valve of the second
skimmer to allow an adequate flow through this
skimmer. This may entail adjustment of the flow
rate to ensure an adequate flow rate through
VICTOR.
SOLUTION
(see "VICTOR is moving too slowly, page 27)
SOLUTION
Replace tyres and "mini-skis"
The 2-wheel VICTOR model turns every 2.5 to
3 m and is designed for pools up to 11 m long.
The 4-wheel VICTOR model turns every 3 to 4
m and was designed for pools up to 12 m long.
If you are using a 4-wheel VICTOR in a
smaller pool, you may wish to install a 2-wheel
steering cam to provide more frequent turning.
2008/05- Indice de révision : B - code : 0030010
29/56
SOLUTION