Final Connection; Speed And Adjustments - Procopi Victor Manuel D'installation Et D'utilisation

STEP 5: FINAL CONNECTION
a. IMPORTANT! Before making the final connection to your pool make sure that power to the pump
is cut and in the "OFF"position. Pump suction can be very dangerous!
b. Firmly press the Bypass valve and valve cone into the vacuum point (or the bottom of a skimmer).
c. Installation is complete. Adjust the speed.
Connection to a vacuum point
(preferred solution)
STEP 6: SPEED AND ADJUSTMENTS
With the pump running close all suction valves except
that to which VICTOR is connected (vacuum point or
skimmer).
VICTOR will start to move, cleaning the pool. Monitor
the rate at which its right wheel rotates. It should
complete 11 to 13 rotations per minute.
If the rate of rotation is less than 9 turns per
minute:
Check the filtration assembly :
- cleanliness of the pump prefilter
- cleanliness of the filter
- air inlets (prefilter lid, unions, etc.)
- inadequate pump power.
If the rate of rotation is greater than 13 turns per
minute, reduce the flow to VICTOR:
- open the suction valve (skimmer or main drain)
gradually until VICTOR is moving at the correct
speed.
- install the bypass valve.
If the bypass valve is blocked in the open
position (can occur when the pump is
too powerful):
- reset the bypass valve by rotating the two sections.
- open a suction valve (skimmer of main drain)
gradually to reduce the depressurisation at the
bypass valve.
Bypass valve
Valve cone
Connection to a skimmer
2008/05- Indice de révision : B - code : 0030010
25/56
Bypass valve
Valve cone
(secondary solution)