SATA jet 100 B F RP/HVLP Mode D'emploi page 130

Operating Instructions SATAjet 100 B F (RP / HVLP), B P
EN
Fill with material
Note!
When painting, only use as much material as is required for the specific
procedure.
When painting, maintain the necessary spray distance. After painting,
store or dispose of the material correctly.
■ Unscrew screw-on lid [2-14] from gravity flow cup [2-13].
■ Press drip-stop [2-9] into screw-on lid.
■ Fill gravity flow cup (maximum 20 mm below top edge).
■ Screw the screw-on lid onto the gravity flow cup.
Adjust gun inner pressure
Note!
The air micrometer [1-5] must be fully opened (vertical position) in the
settings [3-2], [3-3] and [3-4].
Note!
The most precise way to adjust the gun inner pressure is with SATA
adam 2 [3-1].
Note!
If the gun input pressure does not reach the necessary level, increase
the pressure in the compressed air circuit.
Too much input pressure results in high trigger forces.
■ Pull trigger guard [1-11] right back.
■ Adjust the gun input pressure to one of the following settings [3-1],
[3-2], [3-3] to [3-4]. Note the maximum gun inlet pressure (see chap-
ter 7).
■ Bring the trigger guard to the starting position.
130