Eq Profiles; Additional Information For Auto On/ Off And Signal Sensing; Specification - Monitor Audio Silver W-12 Manuel Du Propriétaire

EQ Profiles

The Silver W-12 has 3 preset EQ profiles. These are EQ1 (Movies), EQ2 (Music) and EQ3 (Impact).
These profiles change the characteristics of the sound from the subwoofer. We highly recommend
experimenting with the different profiles to see which most suits your room, tastes, environment, etc. An
example of the different profiles do can be seen below:
Silver W12 EQ Profiles
Music Movie
10
8
6
4
2
0
-2
-4
-6
-8
-10
20 30

Additional Information for Auto On/ Off and Signal Sensing

In auto power mode, the method which wakes the system up takes priority until it is put into standby, with
trigger always taking priority over signal sensing.
Signal sense is around 1mV sensitive on both the stereo and LFE inputs.
Some examples can be seen below:
1. The system is woken up with signal. When the signal is stopped, a 20 minute timer will start counting
down to zero. At zero, the system will enter standby again. If a signal is re-introduced within this 20
minute window, the system will reset and stop the timer. The trigger line will not have any effect.
2. The system is woken up with the 12V trigger going high. The signal sense will not affect the state of
the amplifier. The amplifier will automatically enter standby when the 12V trigger line transitions low.
3. The system is woken up with both signal present and the 12V trigger high. Trigger will take the
priority, and signal sense will not have any effect.
8
Impact
40 50 60 70 80 90 100
Frequency [Hz]
Silver W12

Specification

System Format
Low Frequency Response
Upper Frequency Limit
Low Pass Filter Alignment
Amplifier Power Output
Amplifier Classification
Bass EQ Profiles
Phase Control
Auto Sensing
Input Level Requirements
Driver Compliment
Connections
12v Trigger Input
Cabinet Dimensions
(Excluding grille and amp) (H x W x D)
Dimensions
(Including grille, amp & feet) (H x W x D)
Input Impedance
Mains Input Voltage
Power Consumption
Weight (unpacked)
Monitor Audio reserves the right to alter specifications without notice.
monitoraudio.com
Sealed Cabinet with 25mm M.D.F construction
with internal bracing
20Hz (Typical IEC room )
40 – 120 Hz Variable
Active 4th, order 24db/octave
500 Watts Continuous
Class- D amplifier with Switch mode power
supply (SMPSU)
1: Movie, 2: Music, 3: Impact
0 & 180 degrees (switchable)
Line Level >2mV
Standby after 20 minutes if no signal sensed
1 x 12" C-CAM® sub-woofer driver featuring
triple suspension and 3" long throw voice coil
Stereo RCA in, Stereo RCA link out, LFE in, LFE
link out, 12v Trigger in (3.5mm mono mini-jack),
USB (for updating firmware)
5 - 12v via 3.5mm mono mini-jack socket
340 x 340 x 380mm
13 3/8 x 13 3/8 x 14 15/16 Inch
370 x 340 x 410mm
14 9/16 x 13 3/8 x 16 1/8 Inch
>20K Ohms
110 - 120 Vac / 220 - 240 Vac 50/60Hz
(Electronically Auto selected)
400 Watts / 0.5 Watts in Standby (ErP approved)
20.1Kg (44lb 4oz)
9