Spiked Foot Assembly; For Carpeted Floors; Spiked Foot Fixing For Wooden/Hard Floors; Amp Panel - Monitor Audio Silver W-12 Manuel Du Propriétaire

Spiked Foot Assembly

For Carpeted Floors

The Silver spiked foot assembly incorporates a spike for use on carpeted floors and also, a soft polymer
pad (for use on wooden or tiled floors).
Please ensure there are no hidden wires under the carpet that could be damaged by the
spikes.
Locking Nut
Main Threaded
Assembly
Polymer Pad
Spike

Spiked Foot Fixing For Wooden/Hard Floors

For use on solid floors or where spikes are inappropriate, it is possible to use the
foot without the spike. To use the foot in this manner carefully grip the knurled
portion of the spike and rotate anti clockwise to unscrew the spike fully.
You may find it easier to first remove the polymer pad so as to gain more purchase
on the spike.
The pad should be replaced before carrying out the levelling operation previously
described.
2
The foot comes fully assembled for use on carpeted
floors. All that is required is fixing into the bottom of
the cabinet. This is achieved by simply screwing the
feet fully into the 4-threaded insert in the underside
of the cabinet. If your carpet has a very thick pile,
remove the soft polymer pad from the foot to ensure
the spike goes right through the carpet into the floor.
With great care turn your cabinet the right way up.
Place the cabinet in your desired location, and check
that it is level on all sides. If it is slightly uneven,
unscrew the spike at the lowest point and check
again.
Continue this process until the cabinet is fully level.
Use the locking nut on the foot to fix the foot in place
and to stop any unwanted vibrations.
Silver W12

Amp Panel

1
2
3
4
5
6
7
8
9
1. Crossover Frequency Control
The crossover frequency control only operates when connected to the stereo inputs. It does not have
any effect when connected to the LFE input. This control feature is used to set the upper frequency
limit (low pass) of the Silver W-12. The crossover control should be set in accordance with the size
or bass output of the main/satellite speakers. Refer to the following chart as a guide to setting the
crossover frequency control to the optimum position. Much will depend on the correct low frequency
response of the main speakers and their position within the room. Experimentation is advisable.
Type of Main Speaker
Large floor-standing speaker
Small floor-standing speaker
Large stand-mount/ bookshelf speaker
Small stand-mount/ bookshelf speaker
Small satellite speaker
monitoraudio.com
AC110-120V ~ 50-60Hz
AC220-240V ~ 50-60Hz
400 W
FUSE: 110-120VAC T5AL/250VAC
FUSE: 220-240VAC T5AL/250VAC
Intertek
3100294
Notes:
1. LOGO, TEXT AND LINE TO BE SILK SCREENED PANTONE
COOL GREY 1M
Crossover 2. DO NOT SILK SCREEN LOGO IN RED. TEXT FOR REFERENCE ONLY.
3. IMAGE FOR REFERENCE PURPOSES ONLY.
Control Setting
4. VERSION 10
40-60 Hz
50-70Hz
50-80 Hz
60-90 Hz
80-120 Hz
10
11
11a
3