Installing And Threading Welding Wire - Miller Super S-32P Ultra-Lite Mode D'emploi

3-8. Installing And Threading Welding Wire

1
A
C
WOOD
2
Tighten
3
B
D
1 Retaining Ring
2 Hub Tension Adjustment Nut
Installing Wire And Adjusting
Hub Tension:
Remove retaining ring, and install
spool so hub pin fits spool hole. Re-
install retaining ring.
Adjust tension nut so only a slight
force is needed to turn spool.
Threading Welding Wire:
3 Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
A Open pressure assembly,
hold wire tightly, and cut off
end. Push wire through
guides into gun.
B Close and tighten pressure
assembly. Press gun trig-
ger until wire comes out
gun.
C Feed wire against wooden
surface, and tighten knob
so wire does not slip.
D Cut off wire, and close
door.
Tools Needed:
9/16 in
ST-800 586-B / Ref. ST-159 048-A / S-0627-A
OM-184 517 Page 15