Table Des Matières - Stanley POP Avdel ProSert XTN20 Mode D'emploi

Original Instruction
© 2015 Stanley Black & Decker, Inc.
All rights reserved.
The information provided may not be reproduced and/or made public in any way and through any means
(electronically or mechanically) without prior explicit and written permission from STANLEY Engineered
Fastening. The information provided is based on the data known at the moment of the introduction of this
product. STANLEY Engineered Fastening pursues a policy of continuous product improvement and therefore
the products may be subject to change. The information provided is applicable to the product as delivered
by STANLEY Engineered Fastening. Therefore, STANLEY Engineered Fastening cannot be held liable for any
damage resulting from deviations from the original specifi cations of the product.
The information available has been composed with the utmost care. However, STANLEY Engineered Fastening
will not accept any liability with respect to any faults in the information nor for the consequences thereof.
STANLEY Engineered Fastening will not accept any liability for damage resulting from activities carried out
by third parties. The working names, trade names, registered trademarks, etc. used by STANLEY Engineered
Fastening should not be considered as being free, pursuant to the legislation with respect to the protection of
trade marks.
CONTENT
1. Safety Definitions
2. Specification
2.1 Placing Tool Specification
2.2 The Package Contains
2.3 Main Components List
3. Tool Setup
4. Operating Instructions
4.1 Nose Equipment
4.2 Air Supply
4.3 Setting Instructions
5. Operating Procedure
6. Servicing the Tool
6.1 Daily Servicing
6.2 Weekly Servicing
7. Declaration of Conformity
8. Protect your investment . Warranty registration
E N G L I S H
PAGE
6
8
8
8
9
10
10
10
11
11
12
13
13
13
14
15
5