Wall Or Fl Oor Installa On - AERMEC Omnia UL 26 R Manuel D'installation Et D'entretien

EN
4. WALL OR FLOOR INSTALLATION
4.2.1. DESCRIPTION
The components for the unit installa on are
contained in the packaging.
Before proceeding with the installa on open
the packaging and remove the items contained
inside:
−
Omnia UL_R or Omnia UL_RI, assembled.
−
Electrosta c fi lter material.
4.2.2. INSTALLATION
−
Remove the casing by unscrewing the
screws.
−
For fl oor moun ng ensure a minimum clear-
ance of 80 mm from the ground. For fl oor
moun ng with the foot accessory refer to
the instruc ons supplied loose with the
accessory.
−
For wall moun ng the support structure
must be completely fl at. Use four expansion
plugs (not supplied) suitable for the wall, to
a ach the unit.
Model OMNIA UL_R - UL_RI 26
A (mm) 980
B (mm) 725
C (mm) 701.5
D (mm) 629
E (mm) 735
1 Adjustable discharge louvres
2 Casing
3 Main structure
4 Foot (accessory)
5 Connection space
−
A ach any accessories.
−
To modify the electronic thermostat dip-
switch se ngs access through the panel on
the side of the unit (see chapter ELECTRICAL
CONNECTIONS "DIP-SWITCH SETTINGS").
−
Carry out all connec ons.
−
Mount the casing.
−
Check the correct opera on of the fan coil
unit.
−
Fit the air fi lter. The fi lter is supplied in
sealed packaging, to be opened only at the
me of use.
WARNING
The support structure must be com-
pletely fl at. Use four expansion plugs
(not supplied) suitable for the wall, to
a ach the unit.
24
36
1200
945
921.5
849
955
WALL MOUNTED
Omnia UL_R/UL_RI 26-36
WALL MOUNTED WITH FEET ZU
(accessory)
Aermec cod. 6976420_02 14.05