EUROM Golden 2000 Amber Smart Rotary Manuel D'utilisation page 30

 Adjust the desire radiation angle of the device. Do this by undoing both adjusting
screws slightly using the Allen key. Make sure you secure them again once you
have made the adjustments! The heater can rotate through approximately 90° -
with wall fastening from 30° upwards to approximately 60° downwards. When
adjusting the angle ensure that the radiator does not radiate heat onto
flammable materials from a short distance!
 Fasten all screws another time firmly and scheck or the heater is firmly mounted.
Now your infra red heater is ready for use.
 For personal protection the installation, to which the Eurom Golden 2000 Amber
Smart Rotary is connected, has to be equipped with an earth fall device (max. 30
mAmp).
Under some circumstances it may be attractive to make a fast connection between
the heater and the main supply, and to operate the heater with a switch. Because
the Eurom Golden 2000 Amber Smart Rotary has a high water tightness (IP65) and
for safety reasons, such a connection has to be made by a qualified electrician.
Working
Check for every use:
- or the appliance doesn't show signs of damage.
- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating
duet o wind or rain could lead to loose.
- or there are no objects, canvas, sun screens etc. are inside the safety distances.
- or the socket you want to use gives the correct tension (220-240V-50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Golden 2000 AMBER SMART Rotary has a remote control that works with two
batteries: AAA, 1.5V.
While using, point the remote control to the
receiving point of the heater. If there are
obstacles between remote control and the
heater, it will not work!
 Press the on/off switch (5) on the side of
the unit to "I" (on); The blue light on the
reception point will go on.
 Set the device into operation by pressing
the ON button
The light turns red. The device has a
'slow start' at 33% output. 4 seconds
after starting, it automatically switches
to the most recently used output. On
first use, it will switch to 100% output
after 4 seconds.
 With the Ʌ-arrow, you can switch to a
higher heating level
 With the V-arrow, you can switch to a lower heating level
of the remote control.
30