Zanussi ZOA3572XMU Notice D'utilisation page 23

REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.
The display shows "12.00".
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven for
too long.
There was a power cut.
We recommend that you write the data here:
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Reset the clock.
the oven cavity. Do not remove the rating plate from
the oven cavity.
.........................................
.........................................
.........................................
Remedy
23