Glass Embers - Napoleon LHD45N Instructions D'installation Et D'opération

36
6.5

GLASS EMBERS

EN
CLEAN THE GLASS MEDIA PRIOR TO INSTALLATION. BEFORE APPLYING THE CLEANED GLASS, ENSURE
DO NOT CHANGE OR SUBSTITUTE THE GLASS MEDIA MATERIAL PROVIDED WITH THIS APPLIANCE. IF
REPLACING, USE ONLY THE REPLACEMENT GLASS MEDIA AVAILABLE FROM YOUR AUTHORIZED
DO NOT PLACE ANY MEDIA (GLASS OR VERMICULITE) IN OR AROUND THE PILOT OPENING. THIS WILL
Evenly spread the glass media onto the media tray, ensuring no glass media falls into the pilot opening. If this
happens, insert a clean bag into your vacuum cleaner and vacuum out the glass media. Replacement glass
can be purchased from your local authorized dealer / distributor.
CLEANING GLASS MEDIA
Glass media may have a fi ne oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing around the burner.
WARNING: DO NOT PLACE MEDIA ON OR AROUND THE PILOT, THIS WILL INTERFERE WITH PILOT
OPERATION. USE ONLY MEDIA APPROVED FOR USE WITH THIS APPLIANCE. DO NOT OVERFILL
MEDIA, USE ONLY THE AMOUNT SUPPLIED WITH THE APPLIANCE.
NOTE: Care must be taken to ensure glass embers are kept .250" (6.35mm) clear of the pilot area on
the media tray and aren't interfering with the pilot operation.
Glass embers must not cover burner ports.
When the fl ames impinge on the glass, the glass may discolour slightly and the edges may soften.
W415-1335 / 06.27.14
WARNING
!
THAT IT IS DRY.
DEALER / DISTRIBUTOR.
INTERFERE WITH THE PILOT OPERATION
BURNER
PORTS
PILOT
AREA
74.2B