Vacuum System Motor Filter Cleaning; Solution/Clean Water Filter Cleaning - Nilfisk ALTO SCRUBTEC 545B Manuel D'utilisation

ENGLISH

VACUUM SYSTEM MOTOR FILTER CLEANING

1. Drive the machine on a level ß oor.
2. Turn the ignition key (80) to "0".
3. Open the recovery water tank.
4. If necessary, drain the water from the tank in order to make the Þ lter visible.
5. Check that the pre-Þ lter is clean. If necessary clean it with water and compressed air, then install it.
6. Perform steps 1, 2 and 3 in the reverse order.

SOLUTION/CLEAN WATER FILTER CLEANING

1. Drive the machine on a level ß oor.
2. Turn the ignition key (80) to "0".
3. Close the solution tap (A, Fig. 7) under the machine, behind the right rear wheel. The tap (A) is closed when it is in the position
(B) and it is open when it is in the position (C).
4. Remove the transparent cover (D), then remove the Þ lter strainer (E). Clean and install them on the support (F).
NOTE
The fi lter strainer (E) must be correctly positioned on the housing (G) of the support (F).
5. Open the tap (A).
G
E
26
Bedienungsanleitung auf www.gluesing.net
USER MANUAL
F
E
D
SCRUBTEC 545B – 545BL – 553B – 553BL – BOOST 5
Figure 7
A
B
C
P100109
9097054000(2)2009-06 A