Operating The Outdoor Sensor; Operating The Weather Station; Battery Operation - Auriol AFW 2 A1 Mode D'emploi

Operating the outdoor sensor

♦ Open the battery compartment a on the rear of the device
by pushing the battery compartment cover s in the direc-
tion of the arrow .
♦ Insert two type AA batteries into the battery compartment a
as shown .
♦ Close the battery compartment again a . The control LED u
on the front of the outdoor sensor lights up briefly .
Afterwards, the control LED u lights up once every minute
to signal that transmission is taking place .

Operating the weather station

You can either operate the weather station with the mains
adapter z supplied or using batteries .
Mains power operation:
♦ Plug the low voltage plug on the mains adapter z into the
connector socket r on the weather station and connect the
mains adapter z to an easily accessible mains plug .

Battery operation:

♦ Open the battery compartment w on the rear of the device
by removing the battery compartment cover e .
♦ Insert two type AAA batteries into the battery compartment w
as shown .
♦ Close the battery compartment w again .
Once the power supply has been established, the display will
light up and go through a brief check of the display elements .
│ GB │ IE
■ 48
AFW 2 A1