Safety Instructions For Batteries; Before Initial Use; Setting Up Devices; Putting The Outdoor Sensor Into Operation - Auriol Z31092 Instructions D'utilisation Et Consignes De Sécurité

they have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.
Under no circumstances should you take the
device apart. Repairs should only be carried
out by specialist personnel.
Safety instructions
for batteries
DANGER TO LIFE! Batteries can be swal-
lowed, which may represent a danger to life.
If a battery has been swallowed, medical
help is required immediately.
Remove the batteries from the device if they are
not going to be used for a prolonged period.
CAUTION! DANGER OF EXPLOSION!
The batteries must never be recharged!
When inserting the batteries, ensure the
correct polarity! This is shown in the battery
compartments.
If necessary, clean the batteries and device
contacts before inserting the batteries.
Remove spent batteries immediately from the
device. There is an increased danger of leaks!
Batteries must not be disposed of in the
normal domestic waste!
Every consumer is legally obliged to dispose
of batteries in the proper manner!
Keep batteries away from children. Do not
throw batteries into a fire. Never short-circuit
them or take them apart.
Always replace all the batteries at once.
Use batteries of the same type only.
If the above instructions are not complied
with, the batteries may discharge themselves
beyond their end voltage. There is a danger
of leaking. If the batteries have leaked inside
your device, you should remove them immedi-
ately in order to prevent damage to the device!
Avoid contact with the skin, eyes and mucous
membranes. Any parts of the body coming
into contact with battery acid should be
rinsed off with copious amounts of water
and / or a doctor contacted if necessary!

Before initial use

Put the batteries first into the outdoor
sensor, then into the weather station.

Setting up devices

CAUTION! When selecting a location to
set up the devices, please ensure that they are
not exposed to any direct sunlight, vibrations,
dust, heat, cold or moisture. Do not place the
devices close to sources of heat, e.g. radiators.
Otherwise they may be damaged.
6 GB/IE
94604_aur_Funk-Wetterstation_content_GB_FI_DK.indd 6
Place the weather station on the accompany-
ing base .
35
Note: Please ensure that the pins in the
stand are inserted into the corresponding
35
recesses on the weather station.
Do not place the devices on valuable or sen-
sitive surfaces unless these are appropriately
protected. Otherwise they may be damaged.
Do not place the devices near sources of in-
terference such as television sets, computers,
thick walls etc. Otherwise the transmission of
radio waves between the devices may be
impaired.
Please ensure that neighbouring devices are not
operated at the same frequency of 433 MHz.
Such devices may cause interference to the
radio connection.
Do not place the devices next to or on metal
plates. Otherwise the quality of radio wave
transmission may be reduced.
Do not install the devices in buildings made
of reinforced concrete, e.g. airports, high-rise
buildings, factories or cellars. Otherwise the
transmission of the radio waves between the
devices may be severely impaired.
Putting the outdoor
sensor into operation
Removing the battery safety strip:
Remove the battery compartment cover from
the back of the outdoor sensor.
Remove the battery safety strip. The outdoor
sensor is now ready for operation and the
control LED lights up briefly.
36
Close the battery compartment cover.
Installing the Outdoor Sensor:
Find an appropriate place for the outdoor sensor.
Note: Please ensure that you install the
outdoor sensor within a radius of 100 m
from the weather station. Check that there
are no obstacles between the outdoor sensor
and the weather station. Otherwise there may
be interference of the transmission of data.
For wall mounting:
Hang the outdoor sensor with the mount
on one screw.
Putting the weather
station into operation
Removing the battery safety strip:
Open the battery compartment
back of the weather station.
Pull out the battery safety strip.
Then close the battery compartment
Press the RESET button
light up briefly.
As soon as the battery safety strip has been
removed, the weather station starts to receive
the radio signal.
38
on the
34
.
34
. All of the symbols
33
28.08.13 13:16