Wet Vacuuming - Nilfisk Advance SC6500 40C Mode D'emploi

WET VACUUMING

Steps to follow in tting the machine with optional attachments for wet vacuuming.
1 Disconnect the recovery hose from the squeegee (17). Connect the coupler and hose from the wand kit to the recovery hose.
2 Attach suitable wet pick-up tools to the hose. (An optional Wand Kit PN56413687 is available from Advance).
3 Turn the Master Key Switch (A) ON and press the Vacuum/Wand Switch (I). The vacuum motor and the pump will run continuously until the switch is
pressed again to turn it OFF. NOTE: The "Recovery Tank FULL" indicator is disabled when the wand mode is activated. The oat will stop the ow into the
recovery tank.
SERVICE NOTE: Refer to the service manual for detailed functional descriptions of all controls and optional programmability.
K3
0.2
K1
F
FIGURE 8
19
2/2014
K9 K5
1:400
J G
E
1
17
INSTRUCTIONS FOR USE
!
K7
I
D
23
8
56091095 - SC6500
!
K8
A
L
B
C
5
ENGLISH - A
6
A - 17