Fitting The Back To The Chair - Sunrise Medical JAY ZIP Back Manuel De L'utilisateur

E NG L IS H
DETERMINING COMPATIBILITY
Wheelchair Types
The ZiP Back is designed to be compatible with most
wheelchairs with the following exceptions:
WARNING
• Wheelchairs that are angularly adjustable, recline
or tilt and result in a back angle greater than 60
degrees from the vertical should not be used.
• Use with these types of wheelchairs may cause the
back to accidentally disconnect from the wheelchair
resulting in a fall and the potential for serious injury.
Wheelchair Dimensions
The JAY ZiP Back is designed to replace the
wheelchair's sling upholstery.
Prior to installation determine if the wheelchair used
has compatible back canes, by measuring the width
between your back canes as seen in Figure 3.0.
Using that measurement, check Figure 4.0 to determine
if the back will fit your chair.
next check that the back canes are a compatible
diameter.
The ZiP Back hardware can be mounted on wheelchair
back canes that measure in diameter 3/4",(19mm), (with
insert), 7/8", (22-23mm), (with insert) or 1", (25-25.5mm),
(no insert). (Figure 5.0).
CAUTION
if you cannot determine that the back canes are
compatible, please contact your authorized Sunrise
Medical provider or Sunrise Medical customer service.
JAY Zip Back 122962

FITTING THE BACK TO THE CHAIR

Fig.3.0
Width of back canes from outside to
Fig.4.0
outside of the tubes (Fig. 3.0)
ZiP Back Width* Minimum width
(all contours) inch
8" (20 cm) 7.875
10" (25 cm) 9.875
12" (30 cm) 11.875
14" (35 cm) 13.875
Fig.5.0
insert for 3/4" (19 mm)
diameter
back canes
7
Maximum width
mm inch mm
20.00 9.125 23.18
25.00 11.125 28.26
30.16 13.125 33.34
35.24 15.125 38.42
insert for 7/8" (22-23 mm)
diameter
back canes
US = Rev. A, EU = REV.2.0