Premium Carbon Filter Installation Instructions; Control Panel Operation - Friedrich Kühl KCS08 Manuel D'installation Et D'utilisation

Premium Carbon Filter Installation Instructions

STEP 1. Remove the filter from the unit as per the instructions on the
inside of the filter door.
STEP 2. Hold the filter at the top and slide the grip out as shown in
Figure 4.
STEP 3. If you already have a carbon filter installed remove the dirty filter
by laying the filter down and swinging open the front frame as
shown in Figure 6.
NOTE:
Make sure the frame with the mesh is facing toward you.
Figure 6
FRONT FRAME WITH
MESH FILTER
FRR050
8
STEP 4. Place the new carbon filter on the top of the back filter frame.
The carbon filter has been cut to the correct dimension and
should fit within the frame as shown in Figure 7.
NOTE: The carbon filter is not a reusable filter, and needs to be replaced
every three months for optimum efficiency.
STEP 5. Slide the filter handle back on to hold the frames together
and slide the assembly into the unit as per the instructions
on the door.
NOTE: The filter handle slides into the frame in only one direction. If the
tab in the frame stops the handle from sliding in, slide the handle
from the other direction. DO NOT FORCE THE HANDLE INTO
THE FRAME.
Figure 7
ALIGN HOLES WITH
PROTRUSION
FRR051

Control Panel Operation

All of the control panel function buttons and mode icons can be viewed in Figure 8.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch
will automatically turn off after 20 seconds of inactivity. The remote control can also be used to turn power ON / OFF (see Remote Control).
Display – The display is a high efficiency LCD with a built-in backlight. After 20 seconds of inactivity, the display switches off. Touching any button
automatically changes the display to full brightness.
There are three control push buttons on each side of the display.
Figure 8
SYSTEM FAN MODE FAN SPEED TEMPERATURE
Cycles between Sets fan to either: Sets fan speed: Increment UP
AUTO, HEAT, - Cycle automatically LOW, MED,
COOL, or FAN - Run continuously HIGH or AUTO
TEMPERATURE
ONLY (if equipped)
Increment DOWN
(if equipped)
Figure 9
MODE
Cycles between
COOL, HEAT, FAN
COOL HEAT FAN ONLY -AUTO-
ONLY or -AUTO-
Automatically switches
(if equipped)
between cool & heat
FAN FAN SPEED 2 DIGIT DISPLAY
Sets fan to either: Sets fan speed: Shows Setting for:
- Automatically cycle LOW, MED, HIGH, OR MAX - Set Point (Temperature)
- Continuously run (Actual settings are - Clock (AM/PM)
model dependant)
TIMER IR WINDOW ON / OFF
Turns ON or OFF Do not block Turns unit on/ off
DISCONNECTED CONTROL WI-FI OPERATING
FROM POWER BOARD LOCKED STATE
FILTER TIMER
Check / clean shows on or off
9