Cord Routing Change - Friedrich Kühl KCS08 Manuel D'installation Et D'utilisation

Cord Routing Change

Unplug unit.
WARNING
Electrical Shock Hazard
Make sure your electrical receptacle has the
same configuration as your air conditioner's
plug. If different, consult a Licensed Electrician.
Do not use plug adapters.
Do not use an extension cord.
Do not remove ground prong.
Always plug into a grounded 3 prong oulet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
For convenience and optimum appearance, the direction that the power
cord exits the unit may be changed from left to right by following the
procedure below. Select the exit location on the left or right based on
proximity to the power outlet.
Figure 70
ELECTRICAL
CONTROL
PANEL
NOTE:
DECORATIVE FRONT
REMOVAL USE TOOL PROVIDED.
(SEE FIGURE 69 FOR LOCATION OF TOOL)
FRR054
Remove the 3 screws as shown from the electrical control panel.
Save to reinstall later.
Figure 71
ELECTRICAL CONTROL
PANEL SCREWS (3)
FRR055
38
STEP 16. Carefully pull out electrical control panel 1", but not all the way.
Figure 72
1 INCH
FRR056
STEP 17. Pull electrical cord strain relief downward until free and rotate
90 degrees to the right.
Figure 73
90°
ELECTRICAL CORD
STRAIN RELIEF
FRR057
STEP 18. Push electrical cord strain relief back upward into the electrical
control panel.
Figure 74
ENSURE THE ELECTRICAL CORD STRAIN RELIEF IS FLUSH
WITH THE TOP OF ELECTRICAL CONTROL PANEL.
FRR058
Cord Routing Change continued
STEP 19. Carefully push electrical control panel back into chassis.
Figure 75
ELECTRICAL
CONTROL PANEL
FRR059
STEP 20. Reinstall the 3 screws removed earlier to secure electrical
control panel.
Figure 76
ELECTRICAL CONTROL PANEL SCREWS (3)
(RETAINED FROM STEP 1)
FRR060
STEP 21. If running power cord to the right of the unit, install the cord into
the cord retainer clips along the bottom front of the unit.
Figure 77
CORD RETAINER
CLIPS
POWER
CORD
FRONT
GRILLE
FRR061
39