Installation Instructions; Electrical Requirements - Friedrich Hazardgard SH15 Instructions D'installation Et D'utilisation

NOTE: THIS MANUAL INCLUDES INSTALLATION INSTRUCTIONS FOR BOTH WINDOW MOUNT AND THROUGH-
THE-WALL INSTALLATIONS

Electrical Requirements

ALL FIELD WIRING MUST MEET THE REQUIREMENTS OF THE NATIONAL ELECTRICAL CODE (ANSI/NFPA 70)
ARTICLE 501.
THE FIELD-PROVIDED CIRCUIT PROTECTION DEVICE (HACR CIRCUIT BREAKER OR TIME DELAY FUSE) MUST
NOT EXCEED THE AMPACITY INDICATED ON THE PRODUCT NAMEPLATE.
IMPORTANT: Before you begin the actual installation of your air conditioner, check local electrical codes and the information
below.
Your air conditioner must be connected to a power supply with the same A.C. voltage and frequency (hertz) as marked on the name
plate located on the chassis. Only alternating current (A.C.), no direct current (D.C.), can be used.
An overloaded circuit will invariably cause malfunction or failure of the air conditioner; therefore, it is extremely important that the
electrical power is adequate. Consult your dealer or power company if in doubt.
The following instructions are for HAZARDGARD models and cabinet sizes listed below.
G
SMALL CHASSIS SH15
MEDIUM CHASSIS SH20 , SH24
M o d l e N u
S H 1 5
SH20, SH24
6

Installation Instructions

Models SH15, SH20 and SH24
Explosion Haza rd
Electrically connect unit in acco rdance with NEC
Code Article 501. Failu re to do so can result in
R O U P S
m b r e
WARNING
Electrical Shock Haza rd
re, or electrical shock.
C
(405 mm x 660 mm x 695 mm)
(455 mm x 660 mm x 695 mm)
P u l g T y p e
J u c n o i t n B x o
J u c n o i t n B x o
A B N I E T S Z I E ( H x W x
15 / " x 25 / " x 27 /
15 15 3
16 16
17 / " x 25 / " x 27 /
15 15 3
16 16
Circuit Rating
Time Delay Fuse
2 5 0 V 1 - 5
250V-15 Amp, 250V-20 Amp
D )
"
8
"
8
A m p