Friedrich Kühl KCS08 Manuel D'installation Et D'utilisation page 19

Standard Window Installation continued
Figure 66
TOP OF CABINET
PLACE WINGBOARD PANEL IN WINDOW JAM
TO COMPRESS THE SPRINGS INSIDE THE
RUNNERS, AND SWING THE WINGBOARD
PANELS INTO PLACE AS INDICATED BY THE
DASHED LINES.
WINDOW JAM
CLIP (ITEM 10)
SECTION A-A
A
A
SECURE THE SIDE WINGBOARD PANELS TO
THE SIDE ANGLES WITH FOUR (4) #8 x 1 / " LONG
2
SCREWS (ITEM 11), TWO ON EACH SIDE.
FRR022
36
Figure 67
INSERT FOAM WINDOW
SEAL GASKET (ITEM 12)
A
B
C
SECTION B-B
FRR023
Standard Window Installation continued
OPTIONAL: The factory assembles the supply cord so that it exits the left
side of the unit at the bottom. At the consumer's discretion, pull
the supply cord taut through the loops (refer to Cord Routing
Change, Figure 70) and route the cord down.
STEP 14. To attach and prevent damage to the front grille, align the cord
notch over the cord and center the fresh air lever, then align
and tighten the four (4) captive screws as indicated by the
arrows in Figure 69. Before closing the front panel, be sure
the filter is in place. Make sure curtains do not block the side
air intakes.
STEP 15. Refer to the Control Panel Operation section for instructions.
You are now to control the comfort level of the room.
Figure 68
POWER CORD CLIP
CHASSIS SEAL GASKET (ITEM 13)
Use Tool Provided
Please use the provided tool to attach the decorative front to the chassis.
Figure 69
USE HAND TOOLS
DO NOT
OVERTIGHTEN
B
LOCATION OF GRILLE
REMOVAL TOOL
FRR053
NOTE: WHEN INSTALLING THE CHASSIS
SEAL GASKET, BEGIN AT EITHER BOTTOM
CORNER AND GO UP THE SIDE & ACROSS
THE TOP & DOWN THE OPPOSITE SIDE.
FRR024
37