Switching On And Off; Working With The Hedge Trimmer; Working With The Pole-Mounted Pruner - Parkside PKGA 40-Li A1 Traduction Des Instructions D'origine

If the thread ends can not be
lengthened:
• Turn off the device.
• Press the core insert as far as it will go
and pull firmly on the end of the string.
If no line ends are visible:
• Replace the spool (see chapter on
'Replacing the spool').
Attention! Thread remnants
can be projected and lead to
injuries.
A

Switching on and off

The device has a central on/off
switch (28).
After 2 minutes of non-use, the device
switches off automatically and must
be switched on again via the central
on/off switch (28) before reuse.
As soon as a rechargeable battery
is removed, the device also switches
off automatically.
Ensure your stance is stable and
hold the appliance tightly with both
hands and away from your body.
Before switching the apparatus on,
make sure that it is not touching
any objects.
1. Turn the device on using the on/off
switch (28). The charge status indicator
(27) lights up as long as the device is
switched on.
2. To start, press and hold the safety
switch (29) while pressing the start
switch (30). The hedge trimmer runs at
top speed. You can release the safety
switch (29) again.
3. To switch it off, release the start switch
(30).
4. Turn the device off using the on/off
switch (28).
Working with the hedge
trimmer
While cutting, make sure that you
do not touch any objects, such as
wire fences or plant supports. This
can cause damage to the cutter bar.
• To avoid eye injuries, always wear
safety goggles while working with the
hedge trimmer.
• Always hold the device tightly with
both hands, with one hand on the rear
handle and the other hand on the front
round handle (
Your thumb and fingers must tightly
clasp the handles.
• Check the carrying harness (
comfortable positioning which facilita-
tes holding the hedge trimmer.
• If the blades become jammed with
solid objects, switch the device off
immediately, pull the mains plug, and
remove the object.
• Avoid over-stressing the device while
working.
Working with the pole-
mounted pruner
If the saw chain gets stuck,
do not attempt to pull out the
pruner with force. There is a
risk of injury. Turn the motor
off and use a lever arm or
wedge to release the pruner.
• You will have better control over the
device if you saw using the lower edge
of the blade bar (saw chain in pulling
direction) and not using the upper edge
GB
5).
A
19) for
A
IE
55