Notes On Safety; Symbols In The Manual; Symbols On The Equipment - Parkside PKGA 40-Li A1 Traduction Des Instructions D'origine

Trimmer
Cutting diameter,
spool ........................30 cm / 300 mm
String thickness .................1.8 - 2.0 mm
String length ................................. 5 m
Speed, spool n .................... 7000 rpm
Max. speed, spool n
Vibration on handgrip
(a ) ..............3,649 m/s
h
Vibration on round handle
(a ) .............. 4,676 m/s
h
Sound pressure level
(L ) ................ 86,3 dB(A); K
pA
Sound power level (L
measured .. 93,7 dB(A), K
guaranteed ........................ 96 dB(A)
Brush cutter
Cutting diameter, 3-tooth blade ...25 cm
Speed, blade n .................... 7300 rpm
Max. speed, blade n
Vibration on handgrip
(a ) ..............3,649 m/s
h
Vibration on round handle
(a ) .............. 4,676 m/s
h
Sound pressure level
(L ) ................ 86,3 dB(A); K
pA
Sound power level (L
measured .. 93,7 dB(A), K
guaranteed ........................ 96 dB(A)
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission value
may differ during actual use of the power
........13300 rpm
max
2 ; K= 1,5 m/s
2 ; K= 1,5 m/s
= 3 dB
pA
)
WA
= 2,62 dB
WA
...... 10000 rpm
max
2 ; K= 1,5 m/s
2 ; K= 1,5 m/s
= 3 dB
pA
)
WA
= 2,62 dB
WA
tool from the stated value depending on the
manner in which the power tool is used.
Safety precautions aimed at protecting
the user should be based on estimated
exposure under actual usage conditions
(all parts of the operating cycle are to be
considered, including, for example, times
during which the power tool is turned off
2 and times when the tool is turned on but is
running idle).
2

Notes on Safety

This section describes the basic safety
rules when working with the device.

Symbols in the manual

Warning symbols with infor-
mation on damage and injury
prevention.
2
Instruction symbols with information
2 on preventing damage.
Wear cut-resistant gloves.
Help symbols with information on
improving tool handling.

Symbols on the Equipment

Caution!
Read through the instruction manual
carefully.
Wear safety goggles!
Wear hearing protection!
Wear a safety helmet!
Wear cut-resistant gloves.
GB IE
41