Assembly; Remove/Insert Battery; Mounting The Tubular Shaft; Mounting The Round Handle - Parkside PKGA 40-Li A1 Traduction Des Instructions D'origine

GB IE
cealed power lines. Contact with a live
wire can also cause a charge in metal
parts of the appliance and result in an
electric shock.
• Carefully inspect the surface to be cut,
and remove all wires and other foreign
bodies.
• Check the appliance before each use
for obvious defects such as loose,
worn or damaged parts. Check the
appliance for significant damage or
defects if it is dropped.
Attention! Observe the
safety and operating infor-
mation in the operating in-
structions for your Parkside
X 20 V Team series rechar-
geable battery.

Assembly

Remove the battery from the
device before carrying out
any work on the device.
Only use original parts.
The device can be used with either
the hedge trimmer, pole-mounted
pruner or trimmer attachment, eit-
her with spool or 3-tooth blade.
Dismantling is carried out in reverse
order.

Remove/insert battery

1. To remove the battery (25) from the
device, press the release button on the
battery and pull the battery out.
2. To insert the battery (25), push the
battery along the guide rail into the
device. You will hear it click into place.
50
Only insert the rechargeable
batteries once the device is
completely assembled. Risk
of injury!
Mounting the tubular
B
shaft
Before mounting, remove the pro-
tective cap(s) from the front tubular
shaft (2).
1. Loosen the butterfly screw (3).
2. Pull the lock (8) outward and turn it left
or right as far as it goes.
3. Slide the front tubular shaft (2) onto the
tubular shaft on the device housing (4).
4. Pull the lock (8) outward and turn it
back to its original position.
5. Turn the front tubular shaft (2) with a
gentle rotating movement until the lock
(8) clicks into place in the bore on the
front tubular shaft (2).
6. Fix the tubular shaft in place with the
butterfly screw (3).
Only tighten the butterfly
screw (3) finger-tight. The
use of maximum manual
force will damage the tubu-
lar shaft.
Mounting the round
C
handle
The round handle must be
mounted with a spacing of
at least 25 cm to the device
handle!
The leg protection must al-
ways be mounted on the
operator side!