Mounting The Saw Chain; Mounting The Protective Cover; Removing/Mounting The Protective Cover Extension - Parkside PKGA 40-Li A1 Traduction Des Instructions D'origine

1. Place the round handle (5) onto the
tubular shaft of the device housing (4).
Choose a position within the
levelled adjustment range mar-
ked on the bottom of the tubu-
lar shaft.
2. Position the leg protection (7) onto the
round handle (5) from below.
3. Fix the round handle (5) and the leg
protection (7) with the four hexagon
socket screws (32) using the hexagon
socket wrench (21) from the
storage ( 31).
A

Mounting the saw chain

Pay attention to the correct rotation
direction of the saw chain. This is
indicated on the chain wheel cover
(33) and above the bar bolt (37).
Tension the saw chain in accor-
dance with the first 5-6 steps.
1. Place the device on a level surface.
2. Remove the chain wheel cover (33) by
loosening the nut (34) with the moun-
ting key (23).
3. Place the sawing chain (1) into the bla-
de groove. Place the sawing chain (1)
into the chain sprocket (36).
4. Place the blade bar (35) and saw
chain (1) onto the rail bolts (37). When
the nose on the right below the guide
bolt (37) sits in the lower round recess
on the blade bar, the blade bar is pla-
ced correctly. It is normal for the saw
chain (1) to sag.
5. Pre-tension the saw chain (1) by turning
the screw (38) in a clockwise direction
with the mounting key (23).
6. Put the chain wheel cover (33) back in
position. Tighten the chain wheel cover
nut (34).
Caution! The pole-mounted pruner
can be prone to leaks.
Mounting the protective
cover
The protective cover (14) must be mounted
to the front tubular shaft (2) with the re-
tainer for spool and 3-tooth blade.
1. Screw the protective cover (14) to the
front tubular shaft (2) using the two
small Phillips screws (49). Use the Phil-
lips screwdriver (24) for this.
2. Fasten the cover (50) to the protective
hood (14). Use the hexagon socket
wrench (22) and the three screws (51).
Removing/mounting
the protective cover
extension
If using the 3-tooth blade, the protective
cover extension must be removed.
If using the spool, the extension must be
mounted.
Removing the protective cover
extension:
1. Unlock the lock for the protective cover
extension (56) using a Phillips-head
screwdriver on the side of the string
cutter (15).
2. Remove the protective cover extension
(56).

Mounting the protective cover

extension:
1. Slide the extension (56) onto the pro-
tective cover (14). Begin on the side
without the string cutter (15).
2. Slide the extension (56) up until it clicks
into place.
GB IE
51