Hose Installation - Ultraflex UC 95-OBF Manuel D'installation Et D'entretien

ULTRAFLEX

3.4 Hose installation

The two fittings mounted on the cylinder body are already oriented and are ready to be used. If for practical rea-
sons the orientation must be changed, do as follows:
1. loose the stop nut (A) by using an 11/16" wrench;
2. orient the fittings according to the requirements;
DANGER
Do not unscrew the fittings more than one turn (360°).
3. tighten again the stop nut with a torque of 20[Nm] (15[lb∙ft]) until the washer comes into contact with it.
Screw the hoses on the cylinder fittings with a torque of 20[Nm] (15[lb∙ft]) according to the following instructions:
- minimum hose bend radius 250 mm;
- no interference during engine tilting;
- no interference with the transom;
WARNING
An excessive hose bend could result in its internal breaking which will
cause a bad operation of the system. In this case it is necessary to replace
the damaged hose.
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
A
page 15
-
NO
of 79