Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
3.4 Hose installation
The two fittings mounted on the cylinder body are already oriented and are ready to be used. If for practical rea-
sons the orientation must be changed, do as follows:
1. loose the stop nut (A) by using an 11/16" wrench;
2. orient the fittings according to the requirements;
DANGER
Do not unscrew the fittings more than one turn (360°).
3. tighten again the stop nut with a torque of 20[Nm] (15[lb∙ft]) until the washer comes into contact with it.
Screw the hoses on the cylinder fittings with a torque of 20[Nm] (15[lb∙ft])
according to the following instructions:
-
minimum hose bend radius 250 mm;
-
no interference during engine tilting;
-
no interference with the transom;
WARNING
An excessive hose bend could result in its internal breaking which will
cause a bad operation of the system. In this case it is necessary to replace
the damaged hose.
DANGER
Only use OB-SVS kits with 1740 psi
hydraulic hoses.
HYDRAULIC CYLINDERS FOR OUTBOARD ENGINES
Installation and Maintenance Manual
A
page 19
-
NO
of 71
Publicité
Chapitres
Table des Matières
