Beta ALP 125cc 2008 Mode D'emploi page 128

3
How to remove the plate holder
To remove the back plate holder A
including the lights and indicators, first
remove the saddle, then the tank cover
and the under-saddle plastic shield (see
previous page), then:
•loosen the three screws and the fixing
nuts B of the back plate holder.
•disconnect the electric connections of the
back lights and remove the plate holder A.
WARNING:
The motorbike cannot be driven without
a plate holder and/or lights. It can only
be driven in private tracks and/or traffic-
barred areas.
Removing
Remove the front mudguard by unscrewing
the 4 fixing screw C.
Removing the stand
•Remove the fixing system D (screw and
nut).
•Pull out the stand E while taking care
not to lose the draw spring F.
Notes:
while disassembling the motorbike, take
care not to damage the magnet and the
stand sensor G.
Removing the passenger' s footrests
• Loosen the two screws Hshown in the fig-
ure and remove the passenger's footrest
complete with the frame fixing support.
How to remove the helmet lock
To remove the helmet lock, just remove
the two screws I.
GB
the front mudguard
B
G
E
I
54
A
C
D
F
H