Important - Beta ALP 125cc 2008 Mode D'emploi

• Fit the oil filter cover after fitting the spring
and the O-ring, and then tighten the three
fastening nuts C.
•Fill in with the right amount of oil:
- Oil replacement
- With filter replacement
- Overhaul
•Close the inlet plug B again.dle for a
few minutes.
• Turn off the engine and wait for about
one minute, then check the level and top
up if needed, without exceeding the max
level shown on the window A.
Note
Renew the oil after the first 1,000 km.
Subsequent renewals should be every
5,000 km 15 months, (refer to the table
on page 57). Always use the lubricants
shown on page 37.
The oil filter should be replaced for the first
time when the oil is first renewed, and sub-
sequently every 10,000 km (30 months).

IMPORTANT

Dispose of used oil in compliance
with the regulations in force.
850 ml
950 ml
1300 ml
43
3
GB