Fume Collecting Pipe; Brake Pump Oil - Bleeding The Brakes - Beta ALP 125cc 2008 Mode D'emploi

3

FUME COLLECTING PIPE

Fume collecting tube A is located on the left
side of the vehicle next to the shock absorber.
It comes out of the lower part of the Intake
A
sleeve and is designed to collect the fumes
produced by the engine oil. It is designed to
collect the fumes produced by the engine oil.
Should any oil be found in the tube, remove
the cap at the lower end of the tube and drain
the oil, or the mixture of oil and petrol, into a
suitable container. Disposal is to be made ac-
cording to the regulations in force.
Note
Empty the fume collecting tube every 3,000 km.
IMPORTANT
C
Dispose of used oil in compliance with the
regulations in force.

BRAKE PUMP OIL - BLEEDING THE BRAKES

Front brake
Check that oil is present by looking through oil
level sight B. The minimum oil level should
never be lower than the mark on sight B. To
restore the oil level, loosen the two screws C,
B
D
lift cover D and pour in fresh oil.
Rear brake
Check the oil level through the level light
E. The min oil level must never drop below
F
the mark shown by the warning light E.
To fill up, loosen the two screws F, lift the
plug G and pour in the oil.
G
WARNING
E
A spongy feel of the brake lever may be
due to an air bubble in the braking sys-
tem. Immediately contact an authorized
workshop. In this case, bleed any air out
of the braking circuit.
Note
For information on oil renewals, refer to
the table on page 57. Use the recom-
mended lubricants shown on page 37.
GB
45