Table des Matières
Publicité
EnGLISH
22
Technical Data
Circular table saw
Art. No ................................................................................75205
Service connection .................................. 230 V/ 50 Hz
Rated input........................................................... 1800 w
Idle speed ...................................................... 4500 min
Saw blade dia. x hole dia ..................... 255 x 30 mm
Riving knife ..........................................................2,5 mm
Riving knife guide slot ........................................ 9 mm
Cutting depth max. 90° .....................................82 mm
Cutting depth max. 45° .....................................58 mm
worktable .................................................640 x 580 mm
Warning: The vibration emission level will vary because of the ways in which a power tool can be used and may
increase above the level given in this information sheet.
The vibration emission level may be used to compare one tool with another.
It may be used for a preliminary assessment of exposure.
An accurate estimate of the vibratory load should also take into account the times when the tool is shut down
or when it is running but not actually in use. This may significantly reduce the vibratory load over the total
working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the
tool and the accessories, keep the hands warm, organisation of work patterns.
The appliance meets EN 61000-3-11 requirements and is subject to special connection conditions. That means that
use on optionally selected connection points is inadmissible. The appliance can lead to occasional voltage fluctuations
under unfavourable power conditions. The appliance is only designated to be used for connection points not excee-
ding the maximum allowed impedance of zmax = 0,233 Ω. As a user, you must make sure your connection point on
which you want to use the appliance meets the above-mentioned requirements – after agreement with your electricity
supplier if necessary.
measures stated in the service manual. Act responsib-
ly toward third parties.
In case of any doubts about connection and operati-
on refer please to our customer center
Specified Conditions Of Use
The circular saw is only intended to cut wood and
wood like products.
Do not use this product in any other way as stated
for normal use. Not observing general regulations
in force and instructions from this manual does not
make the manufacturer liable for damages.
Stock having a round or irregular cross
section (such as firewood) must not be cut, as it
can not be securely held during cutting.
GTKS 1800 Pro
Read and understand the opera-
ting instructions before using the
appliance. Abide by all the safety
saw table............................................................640 x 145 mm
weight .............................................................................32 kg
noise and Vibration Information
Sound pressure level L
Sound power level L
-1
wA
wear ear protectors!
Vibration emission value a
Measured according to EN 61029,
1)
uncertainty K=3 db (A)
Measured according to EN 61029,
2)
requirements for operating staff
The operating staff must carefully read the Opera-
ting Instructions before using the appliance.
because wrong using of the appliance can be risky,
only competent persons are allowed to operated it.
Operator must be trained properly concerning adjust-
ment, operation and appliance using.
Qualification: Apart from the detailed instructions
by a professional, no special qualification is necessary
for appliance using.
minimum age: Persons over 18 years of age can
only work on the appliance. An exception includes
youngsters trained in order to reach knowledge
under supervision of the trainer during occupational
education.
Training: using the appliance only requires corre-
sponding training by a professional or the Operating
Instructions. No special training is necessary.
The operator is responsible for accidents or risks to
third parties.
GTKS 1800 Pro
......................................87 db (A)
1)
pA
........................................100 db (A)
1)
............................... <2,5 m/s
2)
h
2
Publicité
Table des Matières
