Intended Use - Gesipa Bird Pro Serie Complément Au Mode D'emploi

GB
Supplement to 1.7 Operation and 1.9 Maintenance
1.7

Intended use

• Insert a blind rivet in the nosepiece.
• With the aid of the riveting tool, insert the blind rivet into the rivet hole.
• Press the riveting tool against the material and overcome the preset triggering force*.
• The rivet setting can then be started in two different ways:
Pressing and holding the switch:
Press and hold the switch to start riveting. The pulling process stops automatically when the rivet reaches
the rear end position. The riveting tool automatically re-assumes the front starting position when the
switch is released.
Tapping the switch:
Riveting is triggered by briefly tapping and immediately releasing the switch. As soon as the mandrel
breaks off, the riveting tool stops and automatically re-assumes the front starting position.
• Riveting can only be triggered when the preset triggering force* is reached at the material to be
joined and the switch is pressed or tapped simultaneously.
• Eject the spent mandrel by tilting to the rear into the spent mandrel container or to the front through
the nosepiece.
*The triggering force of the PowerBird Pro
• 0 N without additional compression spring
• 15 N with 1 additional compression spring
• 30 N with 2 additional compression springs
1.9 Maintenance
Cleaning or changing jaws.
The complete jaw mechanism must be maintained regularly!
• Detach the battery from the riveting tool.
• Unscrew union nut and steel head sleeve and clean inside if necessary.
• Remove the compression springs (possible number of compression springs for triggering force: 0 to
5 springs).
• Unscrew support sleeve with WAF 14 open-ended spanner.
• Using two WAF 17 open-ended spanners release jaw housing from threaded bush.
• Remove jaws, clean and oil sliding surfaces; replace if worn.
• Check jaw pusher for wear and replace if necessary.
• Reassemble the jaw mechanism in the reverse order; screw together jaw housing with adapter; fit
compression springs; tighten steel head sleeve with union nut.
• Reconnect battery to riveting tool.
8
® Gold Edition with spring-loaded trigger system is:
• 45 N with 3 additional compression springs
• 60 N with 4 additional compression springs
• 75 N with 5 additional compression springs
04/2021 - 1431921