Technical Specifications Of The Product - Nice ALTO100C Instructions Et Avertissements Pour L'installation Et L'utilisation

Masquer les pouces Voir aussi pour ALTO100C:

Table des Matières

Les langues disponibles

ALTO100C gearmotor, for swing gates

• Product type: electromechanical gearmotor for the automation of automatic gates and doors with built-in control unit complete with radio recei-

ver for "ECCO5..." transmitters

• Adopted technology: DC motor; epicyclical gear reducer; manual motor release. An internal power supply unit housed inside the motor but

separated from the control unit, reduces the mains voltage to the nominal 24V

• Maximum torque: 100 Nm

• Nominal torque: 50 Nm

• No-load speed:

• Speed at nominal torque:

• Maximum frequency of operating cycles: 50 cycles per hour (maximum 100 cycles per day)

• Maximum time for continuous operating: about 10 minutes

• Application limits: the product can be used with gates with weights up to 180 kg (leaf of 0.8 m) or with leaf lengths of up to 1.6 m and opening

angle up to 110°

• Mains power-supply: 230 V

• Absorbed power: 120 W

• Backup power supply: for "PR200" buffer batteries

• Flashing light output:

• "BUS" output: 1 output with maximum load of 7 ECSBus units

• "SbS" input: For normally open contacts (closure of the contact prompts the "Step-by-Step" command)

• "STOP" input: for normally open and/or 8.2kohm constant resistance type contacts, or normally closed contacts with self-learning of the "nor-

mal" status (a variation with respect to the memorised status generates a "STOP" command

• Radio Aerial input: 50 ohm for RG58 or similar type cable

• Max. cable length: mains power-supply: 30 m; motor outputs: 10 m; other inputs/outputs: 20 m with aerial cable preferably less than 5 m

(observe warnings regarding the minimum section and type of cables)

• Ambient operating temperature:

• Assembly

• Protection rating: IP 44

: 385 x 90 x 123 mm / 4,8 kg

• Possibility of radio control: with "ECCO5..." transmitters, the control unit is set to receive one or more of the following commands: "Step-by-

Step", "Partial Open", "Only Open" and "Only Close"

• Compatible ECCO5... transmitters: up to 256 if memorised in "Mode I"

• ECCO5... transmitter range: from 50 to 100 m. This distance may vary in the presence of obstacles and/or electromagnetic disturbance pre-

• Programmable functions: "semi-automatic" function (after opening the control unit does not re-close the gate automatically) or "automatic"

function (after opening the control unit re-closes the gate automatically); motor speed "low" or "high"; in the case of "automatic" mode the pause

time can be selected from 10, 20, 40, and 80 seconds; "pedestrian" opening can be selected in 4 different modes; system obstacle detection

sensitivity can be selected from 4 levels; "Step-by-Step" command operation can be selected from 4 modes

• Self-programmed functions: self-detection of devices connected to output "BUS"; self-detection of type of "STOP" device (contact type NO,

NC or 8.2 kohm constant resistance); self-detection of the opening angle for each motor; self-detection of number of gearmotors present in auto-

mation (1 or 2)

ALTO100M gearmotor, for swing gates

• Tipologia: electromechanical gearmotor for automations of automatic gates and doors

• Product type: DC motor; epicyclical gear reducer; manual motor release

• Maximum torque: 100 Nm

• Nominal torque: 50 Nm

• No-load speed:

• Speed at nominal torque:

• Maximum frequency of operating cycles: 50 cycles per hour (maximum 100 cycles per day)

• Maximum time for continuous operating: about 10 minutes

• Application limits: the product can be used with gates with weights up to 180 kg (leaf of 0.8 m) or with leaf lengths of up to 1.6 m and opening

angle up to 110°

• Power supply: 24 V

(50%)

• Rated current absorption: 2A; on start-up the maximum absorbed current is 3A for a maximum time interval of 2 s

• Ambient operating temperature:

• Assembly

• Protection rating: IP 44

•

: 385 x 90 x 123 mm / 4,3 kg

––––––––––––

NOTES: • The kit ALTO101START and ALTO100 is produced by Nice S.p.a. (TV) I • In order to improve its products, Nice S.p.a. reserves the right