Nice ALTO100C Instructions Et Avertissements Pour L'installation Et L'utilisation page 46

(*) Warning! - If the post surface width is between 80 and 135 mm,
must be turned through 90°. Then follow the instructions in
b)
then secure the gearmotor using adequate screws and washers.
Note
c) - For increased stability of the gearmotor, adjust its rear feet so that
they are placed against the post. This adjustment can be made later,
graph 5.4).
a) - Loosen the nut of the slotted arm, remove the stop and move the two
pins apart, checking that the distance between them is the same as
the obtained value C. Then tighten the nut, but only provisionally.
05.
and 18).
A
11
1
(see paragraph 4.1B)
300
A
250
200
150
100
50
mm
0
.
A
B
B
50 100
B = 145
a) - Move the gate leaf to the maximum leaf closing position against the
travel limit stop.
b)
bracket on the arm. Then,
until the two arms are completely extend-
ed;
the arms are completely extended only when the elbow blocks
against its stop.
c) - Ensure that the gearmotor arm is level (
- to mark the centre of the slots on the bracket (
d)
tape and move the leaf to the maximum opening position, against the
e) - With the leaf in this position, check the gate as shown in
stretch a piece of string passing exactly above the two pins of
the slotted arm through to the leaf hinge pin. If the string is found
between the hinge pin and post in the area of the hinge pin (posi-
tion "BB" in ), extend the slotted arm by a few millimetres
(value "C") and repeat the check. Repeat the procedure several times
and the leaf hinge pin (position "AA" in
06.
After ensuring correct operation of the entire arm, cut the excessive
part of the slotted arm as described below.
a)
1 in Then remove the arm from the bracket and cut the
excess section of the arm.
b) - After removing any burrs found after cutting, re-assemble the arm
components with reference to
07.
a) - Drill the leaf at the marked points; remove the bracket from the arm
b)
tant - Check that the bracket and arm are perfectly level. If neces-
sary, loosen the bracket screws and level as required.
c)
as established at the beginning of paragraph 3.4.
08. Checking perfect leaf closure.
a) - Close the leaf completely and ensure that it is placed against the trav-
el stop; then shake by hand to check and ensure that the gearmo-
below; otherwise skip to phase 09:
1.
2. loosen the bracket screws and move it by a few millimetres in the
direction of the gearmotor;
150 200
) and use a pencil
), to enable
), and until the arm no
.
Note
in the same position
EXAMPLE: if value B on the gate post
is measured at mm and value A is
135 mm value C will be 210 mm
C
250
B
English – 10
:
Impor-