GB
D
5.6.
Actual values
The actual values in the VAL menu branch facilitate operation and error diagnostics.
05/ 2014
584
Operation Mode
Setting range:
see operation instructions
Default:
7 - actual frequency
Motor Temp. Operation Mode
the load on synthetic network. The enquiry of the thermo contact
is made via an assigned digital input.
Setting (in extracts):
Default:
1
) only possible in Config 701
2
) only possible in Config 700
3
) only possible with use of Expansions module
841 – Synthetic network
Output Current
Display: 0,0 A ... oI
FIN
842 – Synthetic network
Output voltage
Display: 0,0 V ... U
FIN
843 – Synthetic network
Output frequency
Display: 0,00 Hz ... 999,99 Hz
213 – Calculated output power in the current
Active Power
operation point. Product of machine voltage , current and cos phi
Display: 0,0 kW ... P
FIN
259 – The cause which resulted in an error
Current Error
switch-off and the corresponding error code is displayed.
The current error is used for error diagnosis.
Display: F0000 ... F9999
45
3
) - Analog Output EM-S1OUTA
570 – monitoring protects
0 - Thermo-contact switched off
1 - Thermo-contact warning message
2 - Thermo-contact error switch off
0
Quick Start Guide ACU-P